Case study · Lotus

A new pivot-ball for the original Lotus 5-speed gear lever

An owner wanted to keep the original Lotus gear lever rather than buy a replacement. We made just the pivot-ball, in two pieces, so it fits the original lever.

Vehicle
Lotus Elan +2S 130/5, Elite and Eclat
Part
Gear lever pivot-ball, in two halves
Material
Polyamide (PA6/66, nylon)
Process
3D scan · CAD · 3D print
The original pivot-ball on the lever, aged and worn.
The original pivot-ball on the lever, aged and worn.

The part

On the Lotus 5-speed gearbox, as fitted to the Elan +2S 130/5 and the series 1 5-speed Elite and Eclat, the gear lever pivots on a plastic ball that sits in a socket on top of the gearbox. Over the years the original ball breaks down, and the gear change becomes vague and sloppy. Complete replacement levers are available, but this customer didn’t feel they were as good as the original Lotus levers. They asked whether we could make just the pivot-ball, as a two-piece part that could be fitted to the original lever.

The challenge

The original ball is moulded onto the lever, so a new one can’t simply slide on. The replacement had to:

  • come in two halves that close around the lever without removing or modifying it;
  • grip the lever firmly, so it can’t turn or rattle;
  • match the original ball’s size, so it sits in the socket and the gear change feels right;
  • stand up to years of movement in a warm gearbox tunnel.

Our approach

Measure and scan

Measure and scan

We measured the lever, ball and socket with a vernier calliper, and 3D-scanned the assembly to capture the shape of the lever where the ball sits.

Design it in two halves

Design it in two halves

In professional CAD, we modelled a ball split into two halves, each with a curved channel that wraps around the lever. On the joint, two pegs on one half drop into matching holes in the other, and a square key locks into a socket, so the halves line up exactly and can’t shift.

Grease channels

Grease channels

Closed together around the lever, the halves form a ball to the original’s size. Shallow grease channels across the surface hold lubricant where the ball turns in its socket. Nothing on the lever has to be cut, drilled or changed.

Choose the right material

Choose the right material

We print the halves in polyamide (PA6/66, nylon), which is tough, wear-resistant and slides smoothly, so the ball keeps moving freely in its socket.

The new pivot-ball on an original Lotus gear lever, seated in its socket.
The new pivot-ball on an original Lotus gear lever, seated in its socket.

The result

A two-piece pivot-ball, printed in tough, wear-resistant PA6/66, that fits the original gear lever, a Ford part Lotus used in period, and seats in the original socket. Owners keep the lever their car was built with and get back a tight, positive gear change. It fits the Lotus Elan +2S 130/5, and the series 1 Elite and Eclat with the 5-speed gearbox.

“These are very good… the result is far better than before with less play and a more precise shift.”

An Elan +2S 130/5 owner, on an owners’ forum

Buy a pivot-ball

The two-piece pivot-ball is available in our eBay shop, ready to fit to your original lever. All our parts are made in our workshop near Cambridge, printed to order or in small batches rather than stockpiled.

Buy on eBay

Take it with you

The full two-page case study, with more photos and detail.

Download the case study (PDF)

Obsolete isn’t the end.

Got a part that can’t be replaced?

Send us a few photos of the part and tell us which vehicle it’s from. We’ll tell you what’s possible.

More case studies