Case study · Lotus

A new torque plug for the Lotus Elan M100 window winder

The M100’s window winder torque plugs are no longer made, and the originals have perished. With nothing left to measure, we designed a new one from the gears it sits between.

Vehicle
Lotus Elan M100, 1989 on
Part
Window winder torque plug
Material
TPU 95A
Process
3D scan · CAD · 3D print
The original cable drum, with the three dogs that push against the plug.
The original cable drum, with the three dogs that push against the plug.

The part

In the Lotus Elan M100, built from 1989, each electric window is driven by a motor through a worm gear and a cable drum. Between them sits a rubber torque plug: dogs on the gear and drum push against it, so when the window reaches the top or bottom of its travel, the plug takes up the shock rather than the gears and cable. The plugs are no longer made, and after more than 30 years the rubber has degraded and no longer does its job.

The challenge

The original plug was too badly perished to take any measurements from, so the new one had to be designed from the parts it works with. It had to:

  • fit between the three dogs on the drum and the three on the gear, with no play;
  • be firm enough not to crush when the gears are turned by hand, yet give a slight cushion;
  • leave room for the material to bulge as it is squeezed;
  • fit the 4.3 mm space between the drum and the gear.

Our approach

Scan the dogs

Scan the dogs

We 3D-scanned the gear and drum and lined the scans up as they sit in the motor, then measured the width, spacing and height of every dog.

Design between the dogs

Design between the dogs

In professional CAD, we modelled six pads, one for each gap between the dogs, joined by thin webs. Each face is matched to the dog it meets.

Give it room to bulge

Give it room to bulge

The original filled the drum’s channel from wall to wall, but TPU barely changes volume when squeezed, so a part with nowhere to bulge can’t compress. The new plug (grey) leaves about 1 mm at each wall of the drum (purple).

Check the fit

Check the fit

With the gear scan (orange) closed over the model, every pad meets its dog with under a tenth of a millimetre of clearance, so there is no backlash. We print the plug in TPU 95A, a firm, flexible material.

The printed plug seated in the original drum, beside the gear.
The printed plug seated in the original drum, beside the gear.

The result

A replacement torque plug for the Elan M100 window winder, printed in TPU 95A and designed from the dogs it works between. It fits the original gear and drum in the winder assembly, ready to go back into the car. Every key size is a named setting, so the fit can be tuned in seconds.

Buy a torque plug

The torque plug is available in our eBay shop, ready to fit to your window winder. All our parts are made in our workshop near Cambridge, printed to order or in small batches rather than stockpiled.

Buy on eBay

Take it with you

The full two-page case study, with more photos and detail.

Download the case study (PDF)

Obsolete isn’t the end.

Got a part that can’t be replaced?

Send us a few photos of the part and tell us which vehicle it’s from. We’ll tell you what’s possible.

More case studies