Case study · Lotus

A clean finish for the seatbelts in a 1970s Lotus Elan +2

An Elan +2 owner was tired of bare, fraying seatbelt slots in the rear panels. We scanned his panels and made a pair of outlets in the style of the originals, now available to every Elan +2 owner.

Vehicle
1970s Lotus Elan +2
Part
Seatbelt outlets for the rear quarter panels, left and right
Material
ASA
Process
3D scan · CAD · 3D print
A bare belt slot in an Elan +2 rear panel, with the vinyl torn where the belt runs.
A bare belt slot in an Elan +2 rear panel, with the vinyl torn where the belt runs.

The part

In a Lotus Elan +2, the seatbelts pass through slots in the vinyl-covered rear quarter panels. A trim outlet around each slot gives a neat finish and stops the belt rubbing on the edge. This customer owns two 1970s Elan +2s and was frustrated by the bare slots: the outlets are no longer made, and without them the vinyl tears and frays where the belt runs. He asked if we could make something in the style of the original, and kindly lent us a pair of rear panels to scan for the best possible fit.

The challenge

An outlet like this looks simple, but the panel it sits on is anything but flat. The new outlets had to:

  • follow the curve of each panel, so the flange sits down all the way round with no gaps;
  • come as a handed pair, because the left and right panels curve in opposite directions;
  • fit into the existing slots and stay put, with no drilling, screws or glue;
  • look like they belong in a 1970s Lotus interior.

Our approach

Scan the panels

Scan the panels

We 3D-scanned both of the borrowed rear panels, using tracking markers around the slots to capture the shape and the curve of the surface precisely.

Design to the curve

Design to the curve

In professional CAD, we shaped the flange of each outlet to the scanned surface of its own panel, giving a mirrored left- and right-hand pair. Clips on the back hold each outlet in its slot.

Fine-tune the fit

Fine-tune the fit

The scan gave us the curve right first time. We printed test outlets and tried them on the real panels, fine-tuning the depth of the clips and the size of the gap until each one pressed home and sat flush.

A split for easy fitting

A split for easy fitting

A narrow split in the frame gives it the flex to clip into the slot, and lets the belt slide in through the gap, so the seatbelt fixings never need to come off. Each outlet is marked LHS or RHS.

Fitted in the customer’s Elan +2: a clean, finished edge where the belt leaves the panel.
Fitted in the customer’s Elan +2: a clean, finished edge where the belt leaves the panel.

The result

A handed pair of seatbelt outlets, printed in tough, UV-resistant black ASA, that follow the curve of the Elan +2’s rear panels and give the belt slots the finish they were missing.

“They fit perfectly, have the curve and are handed to fit each side. They are better than new!”

An Elan +2 owner, on an owners’ forum

Buy a pair

The outlets are available as a handed pair in our eBay shop, ready to fit. All our parts are made in our workshop near Cambridge, printed to order or in small batches rather than stockpiled.

Buy on eBay

Take it with you

The full two-page case study, with more photos and detail.

Download the case study (PDF)

Obsolete isn’t the end.

Got a part that can’t be replaced?

Send us a few photos of the part and tell us which vehicle it’s from. We’ll tell you what’s possible.

More case studies