Case study · Lotus

New headlight masks for a Lotus Esprit S2

When we were asked about new masks for the Esprit S2’s pop-up headlights, we first checked that one would fit on our printer. Then we scanned an original and made a handed pair.

Vehicle
Lotus Esprit S2
Part
Headlight masks, left- and right-hand
Material
ASA
Process
3D scan · CAD · 3D print
An original mask, worn and discoloured.
An original mask, worn and discoloured.

The part

On the Lotus Esprit S2, each pop-up headlight pod carries a pair of round lamps behind a black mask. The mask frames the lamps and closes off the pod, so it is one of the first things people see when the lights come up. After decades in the sun, many are worn and discoloured. When we were asked whether we could make new ones, the first question was size: at over 300 mm across, we checked that a mask would fit on our printer before going any further.

The challenge

A headlight mask is large, thin and very visible, and the new ones had to:

  • line up with the screw holes on each pod, which vary slightly from car to car;
  • stay flat and undistorted as the mounting screws are tightened;
  • clear the surrounding bodywork without catching as the headlights are raised and lowered;
  • frame the lamps neatly, with the raised rings around each lamp;
  • look right on a classic Lotus, with no visible print lines.

Our approach

Scan and measure

Scan and measure

We 3D-scanned an original mask, then measured the screw hole positions on the headlight pods of more than one car.

Rebuild it properly

Rebuild it properly

Rather than copying the worn original, we modelled a clean new mask in professional CAD, with the scan as our reference for shape and the car measurements for the screw holes.

Improve on the original

Improve on the original

The new model (grey) follows the original scan’s outline. Extra material at the corners stops the mask distorting as the screws are tightened, and the printed-in holes are chamfered on the back to allow for small differences from car to car.

Print it to last

Print it to last

We print each mask in one piece in tough, UV-resistant ASA, as a left- and right-hand pair. A fine texture added to the surface hides the print lines, so the finish is in place straight off the printer.

A new mask fitted to an Esprit S2 headlight pod with all four screws, framing the original lamps.
A new mask fitted to an Esprit S2 headlight pod with all four screws, framing the original lamps.

The result

A handed pair of headlight masks for the Lotus Esprit S2, printed in tough, UV-resistant ASA with a textured black finish. New black screws are included. Because the masks now exist as a precise digital model, more can be printed on demand.

Buy a headlight mask

Left- and right-hand masks for the Esprit S2 are available in our eBay shop, with new black screws included. All our parts are made in our workshop near Cambridge, printed to order or in small batches rather than stockpiled.

Take it with you

The full two-page case study, with more photos and detail.

Download the case study (PDF)

Obsolete isn’t the end.

Got a part that can’t be replaced?

Send us a few photos of the part and tell us which vehicle it’s from. We’ll tell you what’s possible.

More case studies