Case study · Mini

Keeping the original look on a Classic Mini’s new seatbelts

A Classic Mini owner fitting new seatbelts wanted to keep the original Britax belt hangers. We rebuilt a broken one from a 3D scan, checked every detail against the original part, then refined it through testing on the car.

Vehicle
Classic Mini
Part
Britax seatbelt hanger
Material
TPU 64D
Process
3D scan · CAD · 3D print
The hanger as it reached us, split from the fixing hole to the ribbed edge.
The hanger as it reached us, split from the fixing hole to the ribbed edge.

The part

On the original Britax seatbelts in a Classic Mini, a small plastic hanger riveted to the webbing holds the steel latch plate when the belt isn’t in use. This owner was fitting new belts and wanted to keep the hangers. They posted us one, which had split as it came off the old belt, along with some webbing and a latch plate. New ones are no longer made.

The challenge

The hanger is only 55 mm wide, but it does three jobs at once, and the new one had to do them all on the new belt:

  • two hooks on the front that hold the 3 mm steel latch plate when it is dropped in from above;
  • two clips on the back that wrap around the 4 mm webbing and grip it, so the hanger doesn’t slide down the belt;
  • the ribbed top edge and overall shape that give the original its look.

Our approach

Scan and measure

Scan and measure

We 3D-scanned the broken hanger. The latch plate and webbing the owner sent gave us the sizes for the hook and clip gaps.

Rebuild it properly

Rebuild it properly

Rather than copying the cracked part, we modelled a clean new hanger in professional CAD, with the crack designed out. The first version matched the scan with a median difference of 0.28 mm, and we checked every detail against the original, from the half-sunk grip ribs to the pointed tooth on each clip.

Print test hangers

Print test hangers

We printed a series of test hangers in flexible TPU, tuning the fit and the print settings with each one, before the best went on the car for testing.

Refine it on the car

Refine it on the car

Each round of feedback from the car shaped the design. Angled clip lips that pinch the webbing, a point under each clip’s tooth and rounded ridges across the back now hold the hanger firmly, and a thicker 2.5 mm plate stops the ends flexing. We also opened the hook gap and added a lead-in, so the latch plate drops straight in without pushing the hanger down the belt, and filleted every inside hook corner for strength.

The new hanger on the car, holding the latch plate (customer’s photo).
The new hanger on the car, holding the latch plate (customer’s photo).

The result

A replacement Britax-style hanger, printed in tough, flexible TPU 64D, that grips the new webbing firmly and holds the latch plate, so the Mini’s new seatbelts keep their period look. It clips onto the webbing as it is or, where the car’s original belts had riveted hangers, it can be pop-riveted in place like the original.

Buy hangers

The hangers are available in our eBay shop, ready to clip onto your seatbelt webbing. All our parts are made in our workshop near Cambridge, printed to order or in small batches rather than stockpiled.

Buy on eBay

Take it with you

The full two-page case study, with more photos and detail.

Download the case study (PDF)

Obsolete isn’t the end.

Got a part that can’t be replaced?

Send us a few photos of the part and tell us which vehicle it’s from. We’ll tell you what’s possible.

More case studies